Dent Repair in Sioux Falls – Jeep Body Line Crease Dent Removal
Today we are remove a super sharp body line dent. Be sure to check out the repair video below! This damage was located in the drivers upper body line of this 2020 Jeep Cherokee. One big obstacle for this repair was the access to the backside of the damaged area. To access the back side of this dented area we have to go through the upper part of the door where the window channel is. This window in the drivers door is made up of Laminated Safety Glass this creates an issue because we cannot apply pressure to this glass because there is a high chance of the glass breaking upon applying pressure. Because of this glass being sensitive to pressure we then remove the door glass to access this damage. Does your vehicle have this type of glass and is this a factor for your repair?
To learn more about this type of glass be sure to check out our article, CLICK HERE!
First Things First – Computer Diagnostic Scanning:
First we start off by running a Pre diagnostic computer scan to set a baseline for the repair for any existing trouble codes the vehicle might have had prior to any work being done. Learn more about computer scanning here:
Once the computer system is checked we then can start the disassembly process, we first remove the door panel. From there we can access the glass track system and disconnect the glass from the window regulator, this then allows us the safely remove the door glass. From there we can then can apply a heat gun to the damaged area to warm the area up to insure the paint is safe when pushing this damage out. We keep the damaged area between 160-180 degrees fahrenheit. This makes not only the paint soft and allows the paint to move with he metal but also makes the paint not want to split or crack during the repair, this is the most important step of a repair like this, having the metal and painted area hot while repairing insures no paint damage. If we were to just try pushing the damaged area out it would for sure split making the repair ruined.
Tensions Are Rising
Once the damaged area is heated up we apply a Keco Lateral tension tool setup to the area. In a sharp impact like this when the metal is pushed in it can pull the surrounding metal inwards, so to reverse this we have the pull the metal back apart WHILE pushing the damaged area up. A repair like this is what sets the men apart from the boys, this is a type of repair many would mess up for not knowing these types of things or making this repair just an improvement not a full repair like shown. Once the damaged area is flattened back out we can start putting the vehicle back together, first reinstalling the door glass, then attaching it back to the track system and insuring it rolls up and down like it should, then we can reinstall the door panel. After everything is back together we then run another computer diagnostic scan called a Post Scan. This scans the computer system for any codes that might have popped up while doing the repairs, like disconnecting the door panel, door module or other electrical components, even disconnecting the battery prior to doing anything can set multiple codes so it is very important this step is done. Once the system is check out and cleared of any new codes it is good to go down the road once again safely.
Repair Overview
Hopefully this gives you a better understanding of the paintless dent repair process, dents do not just pop out or get removed by a few pushes especially damage like this and having the right technician and tools to do the job is a key ingredient to a successful repair.
Schedule Your Repair Today! CLICK HERE
Have questions on anything we discussed?
Text/Call: 605-205-8865
Email: [email protected]
Website: SiouxFallsDentRepair.com